LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Expedition EL RWD >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Vehicle Dynamic Suspension >> Removal And Installation >> Vehicle Dynamics Module (VDM) >> Removal and Installation

Removal and Installation

NOTE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
  1. NOTE: The Vehicle Dynamics Module (VDM) is mounted to the lower left side of the dash above the parking brake control.

    Disconnect the 2 VDM  electrical connectors.

  2. Remove the VDM  bracket nuts and the module.
    • To install, tighten to 8 Nm (71 lb-in).
  3. NOTE: The VDM  is calibrated with information from the ride height sensors. A new or exchanged VDM  requires that the LH and RH ride height sensors are calibrated and a Pneumatic Test is carried out. For additional information, refer to RIDE HEIGHT ADJUSTMENTS  in this information to Calibrate and Initialize System. Clear C1990 and C1991 DTCs.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals