LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Escape Base, 2.5 7, AWD, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Removal And Installation >> Generator - 2.5L >> Removal

Generator - 2.5L: Removal

NOTE: Do not allow any metal object to come in contact with the generator housing and internal diode cooling fins. A short circuit may result and burn out the diodes. Failure to follow this instruction may result in component damage.
NOTE: The radial arm adapter is a serviceable item. Do not replace the generator if the radial arm adapter is the only concern.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Disconnect the battery. For additional information, refer to BATTERY, BATTERY MOUNTING SYSTEM & BATTERY CABLES article.
  3. Remove the 5 bolts, 1 pushpin and the RH lower splash shield.
  4. Rotate the Front End Accessory Drive (FEAD) belt tensioner clockwise and position the accessory drive belt aside.
  5. Remove the battery harness locator from the lower generator stud.
  6. Remove the generator bolt.
  7. Remove the 2 generator stud nuts.
  8. Working from the top of the vehicle, press the locking tab to release the generator lower air duct from the generator and remove the lower air duct.
  9. Position the generator B+ protective cover aside and remove the generator B+ terminal nut.
  10. Position the generator B+ cable aside.
  11. Disconnect the generator electrical connector.
  12. Remove the generator.
  13. Remove the 3 screws and the generator upper air duct.
scientia non olet · About LEMON Manuals