Driver Air Bag Module: Installation
- Connect the 2 driver air bag module electrical connectors.
- Align the driver air bag module locking pins to the steering wheel and, while pushing inward, seat the 2 driver air bag module locking pins to the steering wheel wire clips.
- When the 2 locking pins are seated, there should be an even gap between the driver air bag module trim cover and the steering wheel.
- Repower the SRS . For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING in the General Procedures portion of this service information.
NOTE:
The driver air bag module electrical connectors are unique and cannot be reversed when connected to the driver air bag module. Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver air bag module. Damage to the connector or component may occur.
NOTE:
Audible clicks will be heard when both wire clips are seated in the driver air bag module.