Restraints Control Module (RCM): Installation
- Position the RCM .
- Install the 3 RCM
bolts.
- Tighten to 12 Nm (106 lb-in).
- Make sure the connector position assurance lever is in the full release position before attempting to connect the connector.
- Position the large RCM
electrical connector into the RCM
.
- With the large RCM electrical connector uniformly aligned to the RCM , lightly push in until a subtle, audible click is heard and slight resistance is felt.
NOTE: Do not push the connector to the point where the lever pivots and seats itself. Light pressure is needed to get the connector into position on the Restraints Control Module (RCM) before using the lever to fully seat the connector. Failure to follow these instructions may result in vehicle damage, equipment damage, component damage and/or system failure. - Connect the RCM
electrical connector.
- Pivot the connector position assurance lever toward the RCM
, drawing the connector in to the RCM
.
- Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
- Pivot the connector position assurance lever toward the RCM
, drawing the connector in to the RCM
.
- Connect the small RCM electrical connector.
- Install the LH and RH floor console lower trim panels
- Install the front seats. For additional information, refer to REMOVAL AND INSTALLATION .
- Repower the SRS . For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
WARNING:
Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
NOTE:
Putting the large Restraints Control Module (RCM) electrical connector into the RCM
on an angle can cause bad electrical connections and damage components.