Pump Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.

NOTE: The smaller gear has a recess on both sides.

NOTE: The smaller recess must face away from the torque converter seal.

NOTE: The larger recess, with the beveled edge, must face toward the torque converter.

Lubricate the gears and thrust washers with clean transmission fluid.

Fig 1: Locating Pump Gears Of Nicks
Courtesy of FORD MOTOR CO.
Using the Drive Pinion Oil Seal Installer, install the pump seal.
- Lubricate the gears and thrust washers with transmission fluid.
Fig 2: Installing Pump Seal
Courtesy of FORD MOTOR CO.
Install the top portion of the pump and install the pump bolts.
- Tighten to 10 Nm (89 lb-in).
Fig 3: Locating Top Portion Of Pump Bolts
Courtesy of FORD MOTOR CO.