LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2010 >> Explorer 4.6 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1363 (MULTIFUNCTION Electronic Modules) >> Removal And Installation >> Driver Seat Module (DSM) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Mountaineer, 2009 Ford Explorer Sport Trac, and 2009 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Prior to the removal of the module, it is necessary to upload the module configuration information to a scan tool. This information must be downloaded into the new DSM after installation. For additional information, refer to MODULE CONFIGURATION article.
    NOTE: This step is necessary only if the DSM is being replaced.
  1. Upload the module configuration information from the DSM. For additional information, refer to MODULE CONFIGURATION article.
  2. Remove the driver seat. For additional information, refer to SEATING article.
  3. Remove the 2 DSM screws.
  4. Disconnect the electrical connectors and remove the DSM.
    5. NOTE: Once the module is installed (if it was replaced) it is necessary to download the module configuration information from the scan tool into the new module. For additional information, refer to MODULE CONFIGURATION article.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals