Removal And Installation: Tailpipe: Installation

Position the tail pipe and connect the rubber isolator.
NOTE: Using an abrasive pad, clean the muffler assembly-to-tail pipe surface area of any rust.

Position the muffler assembly-to-tail pipe and make sure the tab on the muffler assembly is seated inside the notch on the tail pipe and then tighten the Torca® clamp.
- Tighten to 48 Nm (35 lb-ft).
Fig 1: Locating Muffler Assembly-To-Tail Pipe Torca® Clamp
Courtesy of FORD MOTOR CO.
Check to see if the exhaust system isolators are at zero load. If the exhaust system isolators are not at zero load, then carry out the exhaust system alignment procedure. For additional information, refer the EXHAUST SYSTEM ALIGNMENT .