LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2010 >> Expedition EL RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1524 (Engine Cooling System) >> Removal And Installation >> Radiator

Removal And Installation: Radiator

WARNING: This page is about a different car, the 2010 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING -- FOCUS .
  2. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  3. Disconnect the cooling fan motor electrical connector, horn electrical connector and the pin-type retainers.
  4. Remove the 2 bolts and the cooling fan motor and shroud from the vehicle.
    • To install, tighten to 5 Nm (44 lb-in).
  5. Disconnect the upper radiator and overflow hoses from the radiator.
  6. Disconnect the lower radiator hose from the radiator.
  7. Position a suitable jackstand below the lower radiator support to support the cooling module.
  8. NOTE: The cooling module will have to be lifted upward to remove the lower radiator support and then positioned back onto the jackstand.

    Remove the 4 bolts and the lower radiator support.

    • To install, tighten 25 Nm (18 lb-ft).
  9. If equipped, remove the transmission oil cooler tube bracket pin-type retainer.
  10. Remove the 2 condenser core-to-radiator bolts, separate the condenser core and remove the radiator.
    • To install, tighten to 5 Nm (44 lb-in).
  11. To install, reverse the removal procedure.
  12. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals