Removal and Installation
WARNING: This page is about a different car, the 2010 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the RH front seat. For additional information, refer to Seat - Front in SEATING .
- Remove the pin-type retainer and position the RH rear footwell duct aside.
- Remove the 3 stability control sensor cluster bolts and position the sensor cluster to access the electrical connector.
- To install, tighten to 10 Nm (89 lb-in).
- Disconnect the electrical connector and remove the sensor cluster assembly.
- Remove the 2 stability control sensor cluster nuts and the stability control sensor cluster.
- To install, tighten to 8 Nm (71 lb-in).
- To install, reverse the removal procedure.
- Carry out the IVD Initialization sequence. Follow the scan tool directions.