LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2010 >> Edge SE, AWD >> Repair and Diagnosis (Single Page) >> Transmission >> Transfer Case >> Transfer Case - Four Wheel Drive (4WD) Systems >> Removal And Installation >> 4X4 Control Module >> Removal and Installation

Removal and Installation

  1. From below the RH side instrument panel, remove the hush panel.
  2. Disconnect the 4X4 control module harness connector.
  3. Remove the 4X4 control module nut.
    • To install, tighten to 7 Nm (62 lb-in).
  4. Remove the 4X4 control module and bracket.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals