LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Focus S, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Servicing >> Transmission Range (TR) Sensor >> Installation

Transmission Range (TR) Sensor: Installation

    NOTE: Failure to hold the manual control lever while loosening or tightening the manual control lever bolt will transmit rotational torque to the TR sensor and shift mechanism.
    NOTE: Do not fully tighten the bolts at this stage.
  1. Install the TR sensor (automatic transaxle shown in illustration removed for clarity).
    2. Fig 1: Locating TR Sensor
    GF0039740Courtesy of FORD MOTOR CO.
  2. Using the Transmission Range Sensor Alignment Tool, align the TR sensor and tighten the bolts.
    • Tighten to 10 Nm (89 lb-in).
    3. Fig 2: Aligning TR Sensor
    GF0039741Courtesy of FORD MOTOR CO.
    NOTE: Do not use air tools on this bolt. Hold the manual control lever while tightening the manual control lever bolt, failure to the manual control lever shaft or the TR sensor could occur.
  3. Install the manual control lever.
    • Tighten to 30 Nm (22 lb-ft).
    4. Fig 3: Locating Manual Control Lever Bolts
    GF0039742Courtesy of FORD MOTOR CO.
    NOTE: Check the manual control lever is in position 2 same as D position or the selector lever cable will not be adjusted correctly.
  4. Adjust the manual control lever to TR sensor D position.
    1. "L" Low
    2. "D" Drive
    3. "N" Neutral
    4. "R" Reverse
    5. "P" Park
    6. When in position D, the marks on the manual control lever line up with the marks on the TR sensor.
    5. Fig 4: Identifying Control Lever Positions
    GF0043334Courtesy of FORD MOTOR CO.
  5. Connect the selector lever cable and the TR sensor electrical connector.
    6. Fig 5: Locating Transmission Range (TR) Sensor Electrical Connector
    GF0039738Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals