Removal And Installation: Radiator

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding .
Disconnect the cooling fan motor and shroud electrical connector, horn electrical connector and the pin-type retainers.
Remove the 2 bolts and the cooling fan motor and shroud from the vehicle.
- To install, tighten to 5 Nm (44 lb-in).
Disconnect the upper radiator and overflow hoses from the radiator.
Disconnect the lower radiator hose from the radiator.
Position a suitable jackstand below the lower radiator support to support the cooling module.

NOTE: The cooling module will have to be lifted upward to remove the lower radiator support and then positioned back onto the jackstand.

Remove the 4 bolts and the lower radiator support.
- To install, tighten 25 Nm (18 lb-ft).
If equipped, remove the transmission oil cooler tube bracket pin-type retainer.
Remove the 2 condensor core-to-radiator bolts, separate the condensor core and remove the radiator.
- To install, tighten to 5 Nm (44 lb-in).
To install, reverse the removal procedure.
Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding .