LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Explorer 4.6 8, AWD >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> General Procedures >> Torca® Clamp

Torca® Clamp

  1. Remove the nut from the Torca® clamp.
  2. Grind the spot weld from the Torca® clamp and remove the clamp.
  3. Clean the uneven surface area and, using an abrasive pad, clean the Torca® clamp surface area of any rust on the pipe.
  4. Position a new Torca® clamp 3-4 mm (0.12-0.16 in) from the button slot.
    5. Fig 1: Identifying Torca(R) Clamp Position
    GF0027675Courtesy of FORD MOTOR CO.
  5. Rotate the Torca® clamp until it is 83 to 93 degrees from slot in the side of pipe.
    6. Fig 2: Identifying Torca(R) Clamp Tightening Angle (83 Degrees To 93 Degrees)
    GF0027676Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals