LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Explorer 4.0 E, RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 5R55S >> Disassembly And Assembly Of Subassemblies >> Overdrive Planetary Gears >> Assembly

Overdrive Planetary Gears: Assembly

    NOTE: Thoroughly clean all parts and blow dry with moisture-free compressed air.
    NOTE: Use petroleum jelly to hold the No. 2 O/D planetary thrust bearing in place.
  1. Install the No. 2 O/D planetary thrust bearing.
    2. Fig 1: Locating Overdrive Planetary Thrust Bearing
    GF0015639Courtesy of FORD MOTOR CO.
  2. Install the O/D planetary gear carrier into the center shaft and O/D.
    3. Fig 2: Locating Overdrive Planetary Gear Carrier, Center Shaft And Overdrive
    GF0015642Courtesy of FORD MOTOR CO.
    NOTE: Make sure that the No. 12 bearing is in place in the O/D planetary prior to installing the O/D sun gear.
  3. Install the O/D sun gear with the recessed gear teeth facing toward the adapter.
    4. Fig 3: Locating Overdrive Sun Gear
    GF0010270Courtesy of FORD MOTOR CO.
    NOTE: Adapter part number must not be visible after installation.
    NOTE: Inspect the sun gear for damaged or worn teeth.
  4. Install the coast clutch-to-O/D carrier adapter.
    5. Fig 4: Locating Coast Clutch-To-Overdrive Carrier Adapter
    GF0015640Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals