Removal and Installation

Remove the lower steering column shroud.
1. Remove the screws and the lower steering column shroud.
  
  Fig 1: Identifying Lower Shroud Screws
  Courtesy of FORD MOTOR CO.
Remove the upper steering column shroud.
Disconnect the electrical connector and the harness from the retaining clips.

Fig 2: Identifying Upper Steering Column Shroud And Retaining Clips
Courtesy of FORD MOTOR CO.
Remove the selector lever bolt.
- To install, tighten to 18 Nm (159 lb-in).
  
  Fig 3: Locating Selector Lever Bolt
  Courtesy of FORD MOTOR CO.
Remove the selector lever.

Fig 4: Removing Selector Lever
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.