Rear Entertainment Module (RETM): Removal

NOTE: Module configuration is required when a new Rear Entertainment Module (RETM) is being installed.

Upload the RETM configuration to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
NOTE: Open the video display.

Remove the 4 screws.
Remove the RETM .

Pull down on the sides of the RETM to disengage the clips from the bracket.
Using a suitable tool, such as a flat-bladed screwdriver, push the rear most U-hook forward and release the U-hooks.
Hang the RETM on the J-hooks and disconnect the electrical connector.
Remove the RETM from the J-hooks.