Throttle Body: Installation
- Using a new O-ring seal, position the TB
, the vibration damper and tighten the 4 bolts in 2 stages.
- Stage 1: Tighten to 9 Nm (80 lb-in).
- Stage 2: Tighten an additional 90 degrees (one-fourth turn).
- Connect the TP
sensor electrical connector.
- Connect the ETC
electrical connector.
- Position the ACL
outlet pipe-to- TB
adapter.
- Install the 3 ACL
outlet pipe-to- TB
adapter bolts.
- Tighten to 10 Nm (89 lb-in).
- Position the air intake resonator assembly, install the bolt and the clamp.
- Tighten to 10 Nm (89 lb-in).
- Connect the crankcase ventilation tube quick connect coupling to the ACL
outlet pipe-to- TB
adapter. For additional information, refer to
FUEL SYSTEM - GENERAL INFORMATION
article.
- Install the ACL
outlet pipe. For additional information, refer to
INTAKE AIR DISTRIBUTION & FILTERING
article.