Occupant Classification System Module (OCSM) - Power Seat Track: Removal

WARNING: Use care when handling the front passenger seat and track assembly. Dropping the assembly, placing excessive weight on or sitting on a front passenger seat that is not secured in the vehicle may result in damaged seat components. Failure to follow these instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious personal injury or death in a crash.

NOTE: The air bag warning indicator illuminates when the correct restraints control module (RCM) fuse is removed and the ignition switch is ON.

NOTE: The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

Remove the front passenger seat. For additional information, refer to SEATING article.
Disconnect the occupant classification system module (OCSM) electrical connector.
Remove the 2 screws and OCSM.
To install, reverse the removal procedure.
Install the front passenger seat. Do not prove out the SRS at this time. For additional information, refer to SEATING article.
Repower the SRS. Do not prove out the SRS at this time. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
Carry out the appropriate procedure after installation of an OCSM.
- If installing the original OCSM, carry out the Zero Seat Weight Test. For additional information, refer to Occupant Classification Sensor (OCS) System Zero Seat Weight Test .
- If installing a new OCSM, carry out the System Reset procedure. For additional information, refer to Occupant Classification Sensor (OCS) System Reset .