Programming the Autolock Feature Using the Door Lock Control Switch
WARNING: This page is about a different car, the 2009 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The autolock feature can be enabled or disabled independently of the auto-unlock feature.
NOTE:
The autolock feature of the Smart Junction Box (SJB) can also be configured on or off with the scan tool. For additional information on module configuration, refer to
MODULE CONFIGURATION
article.
- Close all the doors.
- Confirm that the ignition switch is in the OFF position.
- Turn the ignition switch from OFF to ON.
- Press the door lock control switch unlock button 3 times.
- Turn the ignition switch from ON to OFF.
- Press the door lock control switch unlock button 3 times.
- Turn the ignition switch from OFF to ON. The horn chirps once to indicate that programming mode is entered.
- To enable/disable the autolock feature, press the unlock button on the door lock control switch then the lock button. The horn chirps once if the autolocks are disabled or twice (one short chirp followed by a honk) if the autolocks are enabled.
- Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.
NOTE:
Steps 4 through 8 must be carried out within 30 seconds.