Torca® Clamp

WARNING: This page is about a different car, the 2009 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.

Remove the nut from the Torca® clamp.
Grind the spot weld from the Torca® clamp and remove the clamp.
Clean the uneven surface area and, using an abrasive pad, clean the Torca® clamp surface area of any rust on the pipe.
Position a new Torca® clamp 0-3 mm (0-0.12 in) from the button slot.

Fig 1: Positioning Torca® Clamp 0-3 mm (0-0.12 in) From Button Slot
Courtesy of FORD MOTOR CO.
Rotate the Torca® clamp until it is 83 to 93 degrees from the slot in the side of the pipe.

Fig 2: Rotating Torca® Clamp Until It Is 83 To 93 Degrees From Slot In Side Of Pipe
Courtesy of FORD MOTOR CO.