Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

Remove the LH rear quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
Disconnect the electrical connectors and remove the Liftgate/Trunk Module (LTM) retaining bolt.
- To install, tighten to 9 N.m (80 lb-in).

NOTE: Do not pull the Liftgate/Trunk Module (LTM) straight up or damage may occur to the mounting mechanism.

Carefully rotate the LTM bracket approximately 45 degrees to release the mount and then pull up to remove the module.

Fig 1: Rotating LTM Bracket

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.
- Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization .