LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Servicing >> Transmission Support Crossmember >> Installation

Transmission Support Crossmember: Installation

  1. Position the transmission crossmember in the vehicle and loosely install the transmission insulator-to-extension housing center screw.
    2. Fig 1: Locating Transmission Mount Center Screw
    GF0015487Courtesy of FORD MOTOR CO.
  2. Loosely install the transmission crossmember-to-floor pan screws.
    3. Fig 2: Locating Transmission Crossmember-To-Floor Pan Screws
    G03982786Courtesy of FORD MOTOR CO.
    NOTE: The transmission support insulator must be neutralized.
  3. Slide the transmission support insulator forward, rearward and side-to-side until the gaps between the transmission support insulator snubber and crossmember are equal.
  4. With the transmission support insulator neutralized, tighten the transmission crossmember-to-floor pan screws.
    • Tighten to 63 Nm (46 lb-ft).
    5. Fig 3: Locating Transmission Crossmember-To-Floor Pan Screws
    G03982786Courtesy of FORD MOTOR CO.
  5. Install the catalytic converter. For additional information, refer to EXHAUST SYSTEM article.
  6. With the transmission support insulator neutralized, tighten the transmission insulator-to-extension housing center screw.
    • Tighten to 70 Nm (52 lb-ft).
    7. Fig 4: Locating Transmission Mount Center Bolt
    GF0014721Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals