LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Focus SES, 2D Coupe, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission External Controls System) >> Removal And Installation >> Selector Lever >> Removal

Selector Lever: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  2. Move the selector lever to the PARK position and remove the selector lever cable from the selector lever.
    1. Remove the selector lever cable eyelet from the ball stud.
    2. Squeeze the tabs and remove the selector lever cable from the selector lever assembly.
    3. Fig 1: Identifying Cable Eyelet And Tabs
    GF0043392Courtesy of FORD MOTOR CO.
  3. Disconnect the selector lever assembly electrical connector.
    4. Fig 2: Identifying Connector
    GF0043393Courtesy of FORD MOTOR CO.
  4. Remove the 4 nuts and the selector lever assembly.
    5. Fig 3: Identifying Selector Lever Nuts
    GF0043028Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals