Removal And Installation
- Disconnect the ignition coil-on-plug electrical connector.
- Remove the bolt and the ignition coil.
- To install, tighten to 10 Nm (89 lb-in).
- Inspect the coil boots for rips, nicks or tears. Remove and discard any damaged coil boots.
- To install, slide the new coil boot onto the coil until it is fully seated at the top of the coil.
- To install, reverse the removal procedure.
- Apply silicone dielectric compound to the inside of the ignition coil boot.
NOTE:
When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.