LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Focus SES, 2D Coupe, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> In-Vehicle Servicing >> Engine Mount >> Removal And Installation

Removal And Installation

  1. Remove the 2 expansion tank bolts.
    • To install, tighten to 4 Nm (35 lb-in).
  2. Lift the coolant expansion tank off of the engine mount stud bolt and position it aside.
  3. Install the Engine Support Bar.
    4. Fig 1: Identifying Special Tool (303--F072)
    GF0039288Courtesy of FORD MOTOR CO.
  4. Remove the 2 engine mount nuts.
    • To install, tighten to 90 Nm (66 lb-ft).
  5. Remove the 2 bolts, stud bolt and the engine mount.
    • To install, tighten to 48 Nm (35 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals