LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Expedition RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle/Transmission External Controls >> Removal And Installation >> Selector Lever Knob >> Removal

Selector Lever Knob: Removal

    NOTE: 6R75 transmission selector lever shown, 6HP26 similar.
  1. Remove the PRNDL trim, console tray and cup holder insert.
    2. Fig 1: PRNDL Trim, Console Tray & Cup Holder Insert
    GF0022868Courtesy of FORD MOTOR CO.
  2. Remove the screw and the console upper trim.
    3. Fig 2: Console Upper Trim Screw
    GF0022869Courtesy of FORD MOTOR CO.
  3. Remove and discard the RH selector lever knob cover.
    1. Start at the bottom front only.
    2. Move towards the top front and remove the cover.
    4. Fig 3: Selector Lever & Right Knob Cover
    GF0022905Courtesy of FORD MOTOR CO.
  4. Remove and discard the LH selector lever knob cover.
    1. Start at the bottom front only.
    2. Move towards the top front and remove the cover.
    5. Fig 4: Selector Lever & Left Knob Cover
    GF0022906Courtesy of FORD MOTOR CO.
  5. Remove and discard the RH selector lever knob screw.
    6. Fig 5: Right Selector Lever Knob Screw
    GF0022907Courtesy of FORD MOTOR CO.
    NOTE: Verify the LH and RH knob body towers are present and not damaged.
  6. Remove and discard the LH selector lever knob screw.
    7. Fig 6: Left Selector Lever Knob Screw
    GF0022908Courtesy of FORD MOTOR CO.
  7. Disconnect the transmission control (TC) switch electrical connector and remove the selector lever knob.
    8. Fig 7: Transmission Control (TC) Switch Electrical Connector
    GF0022909Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals