LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Escape Base, 2.3 Z, FWD, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Diagnostic Tests >> Speed Control >> Pinpoint Tests >> Pinpoint Test G: Flash Code 2 - Stoplamp Switch Circuit Failure >> Normal Operation

Normal Operation

When the speed control actuator carries out the self-test, a voltage signal is sent through circuit CCB08 (VT/WH). Circuit CCB08 (VT/WH) carries the signal to the high mounted stoplamp, which then is routed to ground. If the signal fails to be grounded, flash code 2 is set by the speed control actuator.

This pinpoint test is intended to diagnose the following:

scientia non olet · About LEMON Manuals