LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Escape Base, 2.3 Z, AWD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Control System - Cd4E >> General Procedures >> Selector Lever Cable Adjustment

Selector Lever Cable Adjustment

  1. Place the floor shift selector lever in the Overdrive (Circle D) position.
    2. Fig 1: Identifying Drive (D) Position
    GF0042393Courtesy of FORD MOTOR CO.
  2. Disconnect the selector lever cable end from the manual lever.
    3. Fig 2: Identifying Selector Lever Cable
    GF0042394Courtesy of FORD MOTOR CO.
  3. Place the manual lever in the Overdrive (Circle D) position.
    1. Rotate the manual lever counterclockwise to the PARK position.
    2. Rotate the manual lever clockwise 3 detents to the Overdrive (Circle D) position.
    4. Fig 3: Rotating Manual Lever
    GF0042395Courtesy of FORD MOTOR CO.
  4. Release the selector lever cable adjuster lock.
    1. Pull out on the adjuster lock tabs.
    2. Slide the lock over to unlock the selector lever cable.
    5. Fig 4: Identifying Adjuster Lock Tabs
    GF0042396Courtesy of FORD MOTOR CO.
  5. Align the selector lever cable end to the manual lever ball stud and install it with the adjuster unlocked.
    6. Fig 5: Aligning Selector Lever Cable End To Manual Lever Ball Stud
    GF0042397Courtesy of FORD MOTOR CO.
  6. Slide the adjuster tab in place to lock the selector lever cable.
    7. Fig 6: Identifying Adjuster Tab
    GF0042398Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals