Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Remove the air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
Remove the bolts and remove the accelerator control splash shield.

Fig 1: Identifying Accelerator Control Splash Shield Mounting Screw
Courtesy of FORD MOTOR CO.
- To install, tighten to 6 Nm (53 lb-in).
Disconnect the accelerator cable from the throttle lever and the bracket.

Fig 2: Identifying Accelerator Cable Mounting At Throttle Bracket
Courtesy of FORD MOTOR CO.
Disconnect the accelerator cable from the accelerator pedal and shaft.

Fig 3: Disconnecting Accelerator Cable From Accelerator Pedal Shaft
Courtesy of FORD MOTOR CO.
Depress the clips and remove the accelerator cable from the accelerator pedal and shaft.

Fig 4: Identifying Accelerator Cable Lock Tabs
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.