LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Edge SE, AWD >> Repair and Diagnosis >> Steering >> Steering Column >> Removal And Installation >> Steering Wheel >> Removal And Installation

Removal And Installation

  1. Position the steering wheel in the straight-ahead position and turn the ignition switch to the OFF position.
    • Remove the key.
  2. Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
    3. NOTE: Mark the steering wheel and column shaft for reference during installation.
  3. Remove the steering wheel nut.
    • To install, tighten to 35 Nm (26 lb-ft).
  4. Disconnect the steering wheel switches electrical connector.
    5. CAUTION: Do not remove the steering wheel by hitting the shaft with a hammer. Damage to the column may occur.
  5. Using a suitable puller, remove the steering wheel.
    6. Fig 1: Removing Steering Wheel Using A Suitable Puller
    GF0032049Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
    • Align the steering wheel using the reference mark.
scientia non olet · About LEMON Manuals