LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Crown Victoria Base, 4.6 W >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Servicing >> Digital Transmission Range (TR) Sensor >> Removal

Digital Transmission Range (TR) Sensor: Removal

    WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM article. Failure to follow the instructions may result in serious personal injury.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Disconnect the selector lever cable.
    3. Fig 1: Selector Lever Cable At Transmission
    GF0014071Courtesy of FORD MOTOR CO.
  3. Disconnect the Transmission Range (TR) sensor connector.
    4. Fig 2: Transmission Range (TR) Sensor Electrical Connector
    GF0014070Courtesy of FORD MOTOR CO.
  4. Remove the bolts and remove the TR sensor.
    5. Fig 3: Transmission Range (TR) Sensor Bolts
    GF0014072Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals