LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Taurus SEL >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Controls >> General Procedures >> Selector Lever Cable Adjustment - Floor Shift

Selector Lever Cable Adjustment - Floor Shift

NOTE: The selector lever control cable adjustment procedure must be carried out in the order shown.
  1. Position the transaxle range selector lever in OVERDRIVE.
  2. Loosen the manual control lever-to-selector lever cable nut.
    3. Fig 1: Identifying Lever Cable To Manual Lever Nut
    GF0020529Courtesy of FORD MOTOR CO.
  3. Position the manual control lever in OVERDRIVE.
    • Tighten to 20 Nm (15 lb-ft).
    4. Fig 2: Identifying Lever Cable To Manual Lever Nut
    GF0020529Courtesy of FORD MOTOR CO.
  4. Check the operation of the transaxle in each transaxle range selector lever position.
scientia non olet · About LEMON Manuals