Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Sable and 2005 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the wheel and tire assembly. For additional information, refer to WHEELS & TIRES .
- Remove the bolt and disconnect the brake hose. Remove and discard the copper washers.
- Remove the bolts and the brake caliper (2B120). Inspect the caliper. If the boot is torn or the caliper is leaking, it must be disassembled. For additional information, refer to BRAKE CALIPER .
- To install, reverse the removal procedure.
- Use new copper washers.
- Bleed the brake caliper. For additional information, refer to BRAKE SYSTEM-GENERAL INFORMATION .
WARNING:
Use of any other than approved DOT 3 or DOT 4 brake fluid will cause permanent damage to brake components and will render the brakes inoperative.
WARNING:
Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may lead to personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto painted or plastic surfaces, wash it with water immediately.