Remote Climate Control (RCC) Module Cold Boot Process

The purpose of the cold boot process is to allow the RCC module to re-initialize and calibrate the actuators. To carry out the cold boot process, follow the steps below.

1. Turn the ignition switch to the OFF position.
2. Disconnect the RCC module electrical connectors.
3. Wait one minute.
4. Connect the RCC module electrical connectors.
5. Turn the ignition switch to the ON position.
6. Select any position except OFF on the RCC module.

The RCC module will now initialize and calibrate the actuators. Calibration of the actuators will take approximately 30 seconds.