LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Taurus SE >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System - General Information >> General Procedures >> Toe Adjustment - Front

Toe Adjustment - Front

  1. Using alignment equipment and the manufacturer's instructions, measure the front toe.
  2. Start the engine and center the steering wheel.
  3. Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight forward position.
  4. Remove the clamps.
    5. Fig 1: Locating Clamps
    GF0019795Courtesy of FORD MOTOR CO.
  5. Loosen the tie-rod end adjustment nuts.
    6. Fig 2: Locating Tie-Rod End Adjustment Nuts
    GF0019796Courtesy of FORD MOTOR CO.
    NOTE: Do not allow the steering gear bellows to twist when the front wheel spindle tie rod is rotated.
  6. Rotate the front wheel spindle tie rods.
    7. Fig 3: Identifying Front Wheel Spindle Tie-Rods
    GF0019797Courtesy of FORD MOTOR CO.
  7. Tighten the nuts to 55 Nm (41 lb-ft).
    8. Fig 4: Locating Tie-Rod End Adjustment Nuts
    GF0019796Courtesy of FORD MOTOR CO.
  8. Install the clamps.
    9. Fig 5: Locating Clamps
    GF0019795Courtesy of FORD MOTOR CO.
  9. Recheck the toe settings, adjust as necessary.
scientia non olet · About LEMON Manuals