Seat Position Sensor
| Item | Part Number | Description |
|---|---|---|
| 1 | - | Seat position sensor bolt |
| 2 | - | Seat position sensor electrical connector (part of 14A699) |
| 3 | 14B416 | Seat position sensor |
WARNING:
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.
NOTE:
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate an supplemental restraint system (SRS) fault.
NOTE:
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE:
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
NOTE:
Power seat track seat position sensor shown, manual seat track position sensor similar.
- Position the front seat to the rearmost and upward position.
- Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
- Disconnect the seat position sensor electrical connector.
- Remove the bolt and the seat position sensor.
- To install, tighten to 6 Nm (53 lb-in).
- To install, reverse the removal procedure.
- Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
WARNING:
Always tighten the seat position sensor retaining bolt to specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
NOTE:
Note the position of the seat position sensor locating tab for installation.