LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Removal And Installation >> Restraints Control Module (RCM) >> Removal

Restraints Control Module (RCM): Removal

WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.
WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: When installing a new restraints control module (RCM), always make sure the correct RCM is being installed. If an incorrect RCM is installed, erroneous DTCs will result.
NOTE: The air bag warning indicator illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
  1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
  2. If equipped, remove the shift lever bezel.
  3. Remove the 2 floor console finish panel screws.
  4. Apply the parking brake and remove the floor console finish panel.
  5. Disconnect the electrical connector to the power point and audio input jack.
  6. Remove the 2 center stack wings.
  7. Position the floor console mat aside and remove the 2 front floor console screws.
  8. Remove the mat, the 2 floor console nuts and position the floor console away from the instrument panel.
  9. Remove the 6 screws and pry the instrument panel center finish panel away from the instrument panel.
  10. Disconnect the electrical connectors and remove the instrument panel center finish panel.
    11. NOTE: A similar RCM and connectors are shown.
  11. Disconnect the large RCM electrical connector.
    1. Pinch the thumb tab and pivot the connector position assurance lever all the way back until it stops.
    2. Pull out and disconnect the large RCM electrical connector.
    12. Fig 1: Locating RCM Electrical Connector
    GF0002221Courtesy of FORD MOTOR CO.
  12. Disconnect the small RCM electrical connector.
  13. Remove the 3 nuts and the RCM.
scientia non olet · About LEMON Manuals