Restraints Control Module (RCM): Installation
- Position the RCM and install the nuts.
- Tighten to 12 Nm (9 lb-ft).
- Connect the small RCM electrical connector.
- Make sure the large RCM connector position assurance lever is in the full release position before attempting to connect the connector.
- Connect the large RCM electrical wiring connector.
- Using the connector position assurance lever, pivot it toward the RCM, drawing the connector into the RCM.
- Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
- Using the connector position assurance lever, pivot it toward the RCM, drawing the connector into the RCM.
- Connect the electrical connectors and install the instrument panel center finish panel and the 6 screws.
- Position the floor console and install the 2 nuts and the floor console mat.
- Install the LH and RH center stack wings.
- Connect the electrical connector to the power point and audio input jack.
- Install the floor console finish panel and the 2 screws and release the parking brake.
- If equipped, install the shift lever bezel.
- Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
WARNING:
Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
CAUTION:
Putting the large RCM electrical wiring connector into the RCM on an angle can cause bad electrical connections and damage components.
CAUTION:
Do not push the connector to where the lever pivots and seats itself. Light pressure is needed to get the connector into position on the RCM before using the lever to fully seat the connector.
NOTE:
A similar RCM and connectors are shown.