LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission External Controls) >> General Procedures >> Selector Lever Cable Adjustment

Selector Lever Cable Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Place the selector lever in the D position.
  3. Lift the lock upward on the transmission selector cable lock and remove the cable from the selector lever.
    4. Fig 1: Removing Selector Lever Cable From Selector Lever
    GF0015704Courtesy of FORD MOTOR CO.
  4. Place the transmission manual control lever in the D position by rotating the manual lever clockwise to the extent of travel, then rotate counterclockwise 3 detents.
  5. Install the transmission selector lever cable on the selector lever and push the lock downward to lock the selector lever cable adjustment lock.
    6. Fig 2: Locking Selector Lever Cable Adjustment Lock
    GF0015705Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals