LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System - General Information >> Diagnostic Tests >> Charging System >> Component Tests >> Generator On-Vehicle Tests - Load Test

Generator On-Vehicle Tests - Load Test

  1. Switch the tester to the ammeter function.
  2. Connect the positive and negative leads of the tester to the corresponding battery terminals.
  3. Connect the current probe to the generator B+ output terminal, circuit 2037 (RD).
  4. With the engine running at approximately 2,000 rpm, adjust the tester load bank to determine the output of the generator. The generator output should be greater than the graph shown below. If not, refer back to the pinpoint test or Go to Symptom Chart .
    5. Fig 1: Engine Speed Graph
    GF0016083Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals