LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Servicing >> Transmission Support Crossmember >> Installation

Transmission Support Crossmember: Installation

  1. Position the transmission crossmember in the vehicle and loosely install the transmission insulator-to-extension housing center screw.
    2. Fig 1: Locating Transmission Mount Center Screw
    GF0015487Courtesy of FORD MOTOR CO.
  2. Loosely install the transmission crossmember-to-floor pan screws.
    3. Fig 2: Locating Transmission Crossmember-To-Floor Pan Screws
    G03982786Courtesy of FORD MOTOR CO.
    NOTE: The transmission support insulator must be neutralized.
  3. Slide the transmission support insulator forward, rearward and side-to-side until the gaps between the transmission support insulator snubber and crossmember are equal.
  4. With the transmission support insulator neutralized, tighten the transmission crossmember-to-floor pan screws.
    • Tighten to 63 Nm (46 lb-ft).
    5. Fig 3: Locating Transmission Crossmember-To-Floor Pan Screws
    G03982786Courtesy of FORD MOTOR CO.
  5. Install the catalytic converter. For additional information, refer to EXHAUST SYSTEM .
  6. With the transmission support insulator neutralized, tighten the transmission insulator-to-extension housing center screw.
    • Tighten to 70 Nm (52 lb-ft).
    7. Fig 4: Locating Transmission Mount Center Bolt
    GF0014721Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals