LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> General Procedures >> Transmission Range (TR) Sensor Adjustment >> Adjust

Transmission Range (TR) Sensor Adjustment: Adjust

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the selector lever cable from the manual control lever.
    3. Fig 1: Locating Shift Cable Eyelet At Manual Control Lever
    GF0015451Courtesy of FORD MOTOR CO.
  3. Loosen the screws.
    4. Fig 2: Locating Digital TR Sensor Screws
    GF0015452Courtesy of FORD MOTOR CO.
    CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.
    NOTE: The manual lever must be in the NEUTRAL position.
  4. Using the special tool, align the digital TR sensor and tighten the screws in an alternating sequence.
    • Tighten 8 Nm (71 lb-in).
    5. Fig 3: Identifying Special Tool (307-351)
    GF0015453Courtesy of FORD MOTOR CO.
  5. Install the selector lever cable to the manual control lever.
    6. Fig 4: Locating Transmission Shift Cable At Manual Control Lever
    GF0015454Courtesy of FORD MOTOR CO.
  6. Verify that the selector lever cable is adjusted correctly. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS .
scientia non olet · About LEMON Manuals