LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Controls >> Removal And Installation >> Selector Lever Knob >> Installation

Selector Lever Knob: Installation

  1. Connect the TC switch electrical connector.
  2. Fold the TC switch wire into the selector shaft channel to keep the harness from contacting the sliding mechanisms.
    3. CAUTION: Tightening the screw over 3 Nm (27 lb-in) may damage the selector lever assembly.
  3. Align the selector lever knob base screw hole with the selector shaft and install the screw.
    • Tighten to 3 Nm (27 lb-in).
    4. Fig 1: Locating Screw From Knob Base
    GF0000996Courtesy of FORD MOTOR CO.
  4. Install the transmission selector lever assembly in the vehicle. For additional information, refer to Selector Lever .
scientia non olet · About LEMON Manuals