LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Controls >> Removal And Installation >> Selector Lever Cable and Bracket >> Installation

Selector Lever Cable and Bracket: Installation

  1. Install the selector lever cable bracket and install the 2 bolts.
    • Tighten to 28 Nm (20 lb-ft).
    2. Fig 1: Locating Transmission Shift Cable Bracket Bolts
    GF0015496Courtesy of FORD MOTOR CO.
  2. Install the selector lever cable eyelet onto the transmission manual lever.
    3. Fig 2: Locating Selector Lever Cable Eyelet Onto Transmission Manual Lever
    GF0015451Courtesy of FORD MOTOR CO.
    NOTE: It is necessary to install a new plastic clip prior to installation.
  3. Install the selector lever cable into the selector lever cable bracket.
    4. Fig 3: Locating Selector Lever Cable From Bracket And Discard Clip
    GF0015707Courtesy of FORD MOTOR CO.
  4. Install the selector lever cable onto the selector lever and lock the selector lever cable adjustment lock.
    5. Fig 4: Locking Selector Lever Cable Adjustment Lock
    GF0015705Courtesy of FORD MOTOR CO.
  5. Verify the selector lever cable is adjusted correctly. For additional information, refer to Selector Lever Cable Adjustment .
scientia non olet · About LEMON Manuals