Removal And Installation
- Upload the module configuration information from the DSM into the scan tool. For additional information, refer to MODULE CONFIGURATION article, to carry out programmable module installation (PMI).
- Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
- Remove the driver seat. For additional information, refer to SEATING article.
- Remove the DSM screw.
- To install, tighten to 7 Nm (62 lb-in).
- Disconnect the electrical connectors and remove the DSM.
- To install, reverse the removal procedure.
CAUTION:
Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage to the module may result.
NOTE:
Prior to the removal of the DSM, it is necessary to upload the module configuration information to the scan tool.
NOTE:
Once the DSM is installed, it is necessary to download the module configuration information from the scan tool into the new DSM. For additional information, refer to MODULE CONFIGURATION
article, to carry out PMI.