Output Shaft Speed (OSS) Sensor: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Apply a light coat of clean transmission fluid to the O-ring before installation.

Install the OSS sensor.
- Tighten to 10 Nm (89 lb-in).
- Connect the electrical connector.

Fig 1: Locating Electrical Connector

Courtesy of FORD MOTOR CO.

Lower vehicle.
Check the transmission fluid level and add automatic transmission fluid as necessary.

Fig 2: Identifying Transmission Fluid Level Gauge

Courtesy of FORD MOTOR CO.

Start the engine and move the transaxle range selector lever through all gear positions.