LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Focus ST >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission) >> Disassembly And Assembly Of Subassemblies >> Reverse Clutch >> Disassembly

Reverse Clutch: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the reverse clutch pressure, friction and steel plates.
    1. Remove the retaining ring.
    2. Remove the plates.
    2. Fig 1: Identifying Retaining Ring And Plates
    GF0039866Courtesy of FORD MOTOR CO.
  2. Using the special tool, remove the reverse clutch piston return spring retainer ring and retainer.
    3. Fig 2: Identifying Special Tool
    GF0039867Courtesy of FORD MOTOR CO.
  3. Remove the reverse clutch piston return spring.
    4. Fig 3: Locating Reverse Clutch Piston Return Spring
    GF0039868Courtesy of FORD MOTOR CO.
  4. Remove the reverse clutch piston assembly.
    5. Fig 4: Locating Reverse Clutch Piston Assembly
    GF0039869Courtesy of FORD MOTOR CO.
    CAUTION: If damage is found to the reverse clutch piston seals, install a new reverse clutch piston.
  5. Inspect the seal bore in drum, inner and outer seals.
    6. Fig 5: Locating Inner And Outer Seals
    GF0039870Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals