LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Focus SES, 2D Hatchback, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Controls >> Removal And Installation >> Selector Lever Knob >> Installation

Selector Lever Knob: Installation

    CAUTION: When installing the selector lever knob, make sure the wiring harness is positioned forward and is centered on the shift lever shaft, or damage to the shift lever or wiring harness will occur.
  1. Position the selector lever knob onto the lever and route the wiring harness through the transmission range indicator.
    2. Fig 1: Locating Wiring Harness On Selector Lever
    GF0040026Courtesy of FORD MOTOR CO.
  2. Slide the selector lever knob down the shaft and install a new screw.
    3. Fig 2: Sliding Selector Lever Knob Down
    GF0040027Courtesy of FORD MOTOR CO.
    NOTE: Selector lever assembly shown removed.
  3. Connect the O/D switch electrical connector.
    4. Fig 3: Locating O/D Switch Electrical Connector
    GF0040024Courtesy of FORD MOTOR CO.
  4. Install the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
scientia non olet · About LEMON Manuals