Selector Lever Cable and Bracket - Column Shift: Installation
- Install the selector lever cable bracket and bolts onto the transmission.
- Tighten to 25 Nm (18 lb-ft).
- Install the selector lever cable into the bracket and install the clip.
- Connect the selector lever cable onto the manual control lever and move the locking tab down.
- Listen for the audible click.
- Pull back on the selector lever cable to make sure that it is correctly installed.
- If equipped, install the heat shield.
- Push the selector lever cable and rubber grommet up through the dash panel.
- Connect the selector lever cable onto the steering column.
- Connect the selector lever cable retainer.
- Connect the selector lever cable onto the steering column bracket.
- Connect the selector lever cable onto the selector lever arm ball stud.
- Listen for the audible click.
- Pull back on the selector lever cable to make sure that it is correctly installed.
- Install the steering column lower shroud.
- Install the lower shroud.
- Install the instrument panel lower reinforcement panel.
- Tighten to 9 Nm (80 lb-in).
- Install the hood release cable lever.
- Tighten to 9 Nm (80 lb-in).
- Install the instrument panel lower finish panel.
- Adjust the selector lever cable. Refer to Selector Lever Cable Adjustment .
NOTE:
When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click into place. Pull back on the selector lever cable to make sure that it is locked into the bracket. Also, make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable to make sure that the cable end is correctly installed.
NOTE:
To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the selector lever cable bracket.
NOTE:
When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click into place. Pull back on the selector lever cable to make sure that it is locked into the bracket. Also, make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable to make sure that the cable end is correctly installed.
NOTE:
Install a new heat shield if it is loose on the cable.
NOTE:
When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click into place. Pull back on the selector lever cable to make sure that it is locked into the bracket. Also, make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable to make sure that the cable end is correctly installed.
NOTE:
To prevent cable damage, do not apply force to the selector lever cable assembly between the steering column selector lever arm and the steering column bracket.