LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Removal And Installation >> Safety Canopy Module >> Installation

Safety Canopy Module: Installation

  1. Install new safety canopy module J-nuts.
    2. Fig 1: Safety Canopy Module J-Nuts
    GF0024031Courtesy of FORD MOTOR CO.
    NOTE: If equipped with a moonroof and/or rear window wiper assembly, make sure of correct moonroof drain hose and/or rear window solvent hose routing.
  2. Install the safety canopy rear hook.
    3. Fig 2: Safety Canopy Rear Hook
    GF0024032Courtesy of FORD MOTOR CO.
  3. Hook the safety canopy module to the C-pillar.
    4. Fig 3: Safety Canopy Module Hook At C-Pillar
    GF0024029Courtesy of FORD MOTOR CO.
  4. Install the 2 safety canopy module bolts located near the top of the A- and B-pillars.
    • Tighten to 8 Nm (71 lb-in).
  5. Attach the A-pillar tether pin-type retainer to the A-pillar.
    6. NOTE: If equipped with a moonroof and/or rear window wiper assembly, do not pinch the front moonroof drain hose and/or rear window washer solvent hose.
  6. Install the A-pillar tether bolt.
    • Tighten to 8 Nm (71 lb-in).
  7. Install the 2 safety canopy module bolts near the top of the C-pillar and between the B- and C-pillars.
    • Tighten to 8 Nm (71 lb-in).
  8. Install the 2 bolts to the safety canopy module tether bracket at the C-pillar.
    • Tighten to 8 Nm (71 lb-in).
  9. If the vehicle is equipped with a rear window wiper assembly, position the hose and attach the hose clips.
    10. Fig 4: Hose Clips
    GF0024028Courtesy of FORD MOTOR CO.
  10. If the vehicle is equipped with a moonroof, connect the moonroof rear drain hose.
    11. Fig 5: Moonroof Rear Drain Hose
    GF0024027Courtesy of FORD MOTOR CO.
  11. Connect the safety canopy module electrical connector and attach the connector to the D-pillar.
    12. Fig 6: Passenger Side Safety Canopy Module Electrical Connector
    GF0023983Courtesy of FORD MOTOR CO.
  12. Install the safety canopy module wiring clip to the roof panel brace.
    13. Fig 7: Safety Canopy Module Wiring Clip
    GF0024026Courtesy of FORD MOTOR CO.
  13. Install the remaining 2 safety canopy module bolts near the ignitor (between the C- and D-pillars).
    • Tighten to 8 Nm (71 lb-in).
  14. Install the headliner. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  15. Repower the system. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
scientia non olet · About LEMON Manuals